Forum Title: 2 3/4 Cove Molding Miters
I am lost on this one. I don't cut molding like this enough to remember. I understand Cove is not Crown and should be easier to cut. I have a sliding compound miter saw. 2 3/4 Cove. Trying to make an outside corner at the ceiling wall joint. Can someone tell me what to set the table, tilt and where to place the molding? Does 22.5 on the table, 45 tilt and lay molding flat on the table sound right? I haven't tried this setting yet but somehow I think it might be it. Thanks.
Category: General Contractor Post By: MARCUS WEBER (Upland, CA), 03/14/2018

Tips, Support & Resources For Homeowners

Blog With Home Pro & Storm Repair Contractors In Your Area
See All
requestaquote Get Free Quotes callnow 888-506-9527