Handyman Service Near Me

Post Your Answer/Query Here

Posted By

LILLIAN BUTLER (Buena Park, CA)

Category

General Contractor

Posted Date

3/19/2018 12:00:00 AM

Forum Title

Tight Quarters Cut Out

I am converting a piece of antique furniture into a bath vanity. The piece was constructed with 2 'tops' about 2 apart. I need to get access to the upper (real) top to tighten fixture nuts. All of this needs to be accomplished through the top drawer opening which is 3 H X 12 W. I have tried the flex Dremel, Makita angle drill, Rotax angle tool and none of them will fit. Any ideas? I'm beginning to think about one of those goofy drill bits that are designed to cut on the sides and I'd rather not spend money on a tool that has not been required in the last 40 yrs.
Your Answer/Query:

Your Name

State

City

Quick Link

Tips, Support & Resources For Homeowners

Recently Browsed Building Contractors In Your Neighborhood

Blog With Home Improvement Contractors Near Your Location

See All

Faqs - Message Board - Forums

See All

Browse And Explore Products - Faucets, Replacement windows, Appearance boards, Cement

See All